Crossmember

Description

This BC Broncos Exclusive is made to our specs and tested in many configurations. Using the stock small block or Coyote engines. The cross member is a direct bolt on to the stock frame in the factory threaded holes. It will support the 4R70W/AOD/AODE, 6R80 and some other transmission options including manual and 4×2 . You can use it with the D20 or Atlas II transfer case, depending on the adapter you are using. **Some factory adapters may be used as is or with a spacer. This crossmember is made to fit a stock frame (23-1/4″ between rails) Includes cross member, rubber mount, *adapter bracket, instructions and hardware.

*If required

**We have found 2 versions of the stock 4R70w ford housing, ONLY one will work with our cross member without extra spacing. Typically found in Ford trucks f2tp-7a040-ba, have a look at the picture to see the difference.

If you are using a different transmission other than the options please leave let us know in the notes section of your order (engine, trans and tcase) this will help us determine the options best for your setup.

If you are not sure call us

We have used this crossmember (with adjustments along the way since 2012) For many other options including 4BT, Ecoboost, 347 with 6 speed, ZF, T56, 10R80 even 2 wheel drive options.