81-13002 Fuel Pump Wiring Connector (If Your Harness Does NOT Have Inertia Switch) for Early Ford Bronco

Description

This wire is 13′ long and says FUEL PUMP every 6′. It includes 1 foot of wire that has a connector on one end, and a 3-wire weather pack on the other side. The coil of wire has an inertia switch connector at the wire wall side, and the fuel tank side is left open so you can route the wire like you want, then install the other side of the 3-wire weather pack connector on the wire. We include a 3-wire connector at the fuel tank so you can add in your ground and fuel sender wires to it.

This harness is intended for the guys that want to use but DO NOT HAVE an inertia switch already installed in their harness for EFI or carb. The inertia switch is a safety device that cuts off the fuel in the event of a roll over or crash. We run this in our Baja Bronco, and it works! We rolled our racer end over end at MPH, and didn’t have to worry about fuel pumping everywhere.

The switch is not included. If you don’t have one, please order part# 88-00011.